PoE M.2 HAT+ for Raspberry Pi 5 _MAKE_SENSOR_IMU Input voltage range: 4～24V

Input voltage range: 4～24V

15KV ESD protection Terminal resistor 120R

so no soldering is required to connect it to the rest of your boards

These design details serve to enhance the efficiency of your project development and validation

PoE M.2 HAT+ for Raspberry Pi 5 _MAKE_SENSOR_IMU Input voltage range: 4～24VThe Waveshare PoE M. 2 HAT+ has been designed specifically for the Raspberry Pi 5, integrating Power over Ethernet (PoE) functionality alongside an M. 2 interface, enabling use of high speed NVMe SSDs (sizes 2230 and 2242), including support for SSD booting in Gen2 mode (and Gen3 if you enable it). This board supports the IEEE 802. 3af at network standard and includes a fully isolated switch mode power supply (SMPS), offering your board 5V 4. 5A max.