Installation of mudguards can be done independently, regardless of what type of car: sedan, SUV or truck.
At the same time, you can install sprayers without drilling new holes in the car body.
Installation of mudguards can be done independently, regardless of what type of car: sedan, SUV or truck.
At the same time, you can install sprayers without drilling new holes in the car body.
There are several mudguards manufacturers that guarantee good quality and easy installation.
Consider in stages how to install a new part on the car:
1. It is necessary to clean the wheels well and the place where the splashes of dirt and garbage are attached.
2. Twist the wheels as much as possible to the left in order to maximize the gap between the wing and the bus. Accordingly, to install mudguards on the right wheel, it is necessary to twist the steering wheel to the right.
3. Carefully examine the mudguards. They must be marked with a special mark L or LH- for the left side and R or RH- for the right.
4. If the mudguards are too long and the wheels catch, it is necessary to carefully cut them on the outer side of the scar.
5. Installation openings will be used by those that are currently made by the manufacturer. But, for this it is necessary to remove the screws.
6. After the screws were removed, take the sprayer and attach it to the place where the screws were. The mudguard should match the parameters.
7. Install the screws that were removed in the holes to fix the mudguards. But do not fully tighten.
8. It is necessary to take additional bolts and washers (http: // nissan.Spare parts2/) supplied with a mudguard in the kit, attach them to a spray and screw them into the remaining open holes.
9. When installing additional screws, do not forget to insert the hexagonal nuts between the spray and the wheel, if they were provided in the kit.
10. Before tightening the sprayer, it is necessary to adjust the angle of its location in the car.
11. Fix the mudguards.
12. If there are additional holes on the mudguard for greater stability, and there are no such holes on the car, then, if desired, in any car service they can be drilled.
13. You need to check your work, namely, ride a car. Spraying should not cling the threshold.
As you can see, the installation of mudguards is not a difficult task. They can be installed independently in the garage or in the parking lot.
If there are any difficulties with the installation of mudguards, then, to save time and means, it is best to contact a specialized service.