Car repair with your own hands replacing the ball support of special problems, will not be. To properly extract ball support, it is necessary to make maximum efforts, otherwise they will not fly out. A creak or a loud knock is possible, so it will still pass them to change them.
An extraordinary question arises when you need to change the ball support? The answer to this question will be given to you in the diagnostic center of the chassis, although you yourself can determine this moment. Diagnosis of ball supports is carried out by several options.
First, you need to lower the wheels, raise the car with a jack and remove the wheel. After, take two hands by the top and bottom of the raised wheels, shake it, thereby checking it for the presence of a backlash and staggering. Next, you need to unscrew the nut of the ball of the ball and the bolts attaching the support to the rotary fist.
The second option of car repair with your own hands is a Sharova replacement, more correct, for which you need to find yourself under the machine. We insert the mount between the lever and the edge of the support. In this version, you can see the presence of a backlash.
The third diagnostic option is the most tested. To do this, you must first dismantle the support from the regular place, carefully sort out and check. Squeeze the support in a vice and check the radial and axial backlash of the spell. If you were able to move your finger on the ball support without much effort, then the support should be replaced. To remove the ball support from the car, you need a puller for ball supports, a cylinder spoke, a key 17 by 19 unfortunate, mount, a jack, scrap or a metal pipe and mount in reliable friendly hands.
With such a set of tools, you can easily diagnose, do -it -yourself car repair with a replacement of ball support, literally in half an hour. Before installing a new support, it must be lubricated. To do this, remove the boiler, apply a little litter on your finger and put on the boiler. After installing the puller, press your finger. Your assistant, using a mount, squeezes the lower lever and takes out the support. Screw the new support to the rotary fist, slowly release the lever, heading your finger into the eye. After lowering the lever, tighten the ball of the ball.