If you drive a car of Kalina, and not some very expensive imported car, then you probably thought many times what it would be good, make noise insulation, because the noise in the cabin is nervous and prevents the trip from enjoying the trip.Since viburnum, this is a car produced by a native Russian car concern, and not high cost, all the details under the hood, making a heavy noise that penetrates the salon. In addition, a sufficient amount of noise from the external environment also penetrates the salon.First of all, you will need to start with isolation from noise in the doorway. Since, over time, no matter how expensive and good the car is, its doors wear out and begin to stagger a little and vibrate a little. Although initially this was not. This is due to the fact that you open and close the doors every day many times. The most noisy door is the door from the driver’s side.To do this, you will need to remove the skin, then glue the metal surface of the doors with special materials. Further, after gluing, it will be necessary to fill the space in the door, with some seals or foam so that the door does not vibrate much and does not cause resonance. Only then, they put the casing back.In addition, the noise also penetrates from the trunk. Or even from the street to the trunk, and from there to the salon. Therefore, it will be necessary to remove the sheathing behind the cabin and in the trunk. Then, glue the surfaces with special soundproofing materials. And pour all the cracks with foam. Then, again install the casing.
After that, you need to make noise insulation of the hood in your viburnum. The smallest in the hood is the engine. It will be necessary to glue it with the same materials reflecting the sound, and necessarily heat -resistant, since the hood has high temperature. In addition, you need to smear all the cracks and cover the surface separating the cabin from the hood.Further, if you want to make a good enough sound insulation of Kalina with your own hands, you will need to remove the skin throughout the cabin. Then, completely cover the entire surface with special soundproofing materials. Pour all joints with foam or other reagents, on a liquid basis. Then do the installation of the sheathing back.All this will make your salon quiet and comfortable. It is worth noting that after that, you will have a different acoustics in the cabin. Therefore, the sound will sound different.